Hey Guys,
I had made the following changes to the code, and added the "DEFINE PULSIN_MAX 300" line to the top of the code. It now works for GPIO.3 most of the time but it does not work at all on GPIO.2. The modules are 38Khz dave but i am not sure what you mean by "both will see both signals. Whichever pin is triggered first will seize control. "

<code>
STARTPULSE:
PulsIn GPIO.3,0,CODELENGTH 'MEASURE LOW PULSE (IR LED ON TIME)
IF (CODELENGTH > 200) and (CODELENGTH < 400) Then SENSOR1
PulsIn GPIO.2,0,CODELENGTH 'MEASURE LOW PULSE (IR LED ON TIME)
IF (CODELENGTH > 200) and (CODELENGTH < 400) Then SENSOR2
goto STARTPULSE

SENSOR1:
RXPIN1 = GPIO.3
pin = 1
GOTO CODEPULSES

SENSOR2:
RXPIN1 = GPIO.2
pin = 2
GOTO CODEPULSES
</code>

Thanks Again,
Jeremy