12F675 A/D and GPIO sleep interrupt

[macinug]

Bruce,
Thanks for looking and for some good points.

The bridge voltage (R1/R2) is either 0V or 4V. I used analog as I may need to be flexible on the voltage values later on.

The sleep operation does work fine, but I have disabled global interrupt at the start now.

The problem is that GP4 sometimes goes high of its own accord on switching on. The length of time it stays on varies, after that operation is as I intended. Is this a boot up procedure I have not reckoned with?

Also, have I assembled the bytes of the 10bit A/D correctly?

Cheers

[Bruce]

Your A/D part looks fine. If GPIO.4 is going high on power-up, it's most likely due to you
not initializing the port latches before writing to the tris register. Port latches are unknown
at power-up so it's a good idea to set the port to whatever you want 1st then write to the
tris register.

I.E. GPIO = 0 followed by TRISIO = whatever. Then you know the pins that are outputs will
be at a certain logic level at POR.

You have trisio = %00101001, a few other init lines, a pause 1000, then you write to the
port. You have no idea what value is on the output pins until you write to the port after the
pause 1000. Which may not be good with your outputs controlling a motor!

Note: Reading or writing to a port does not clear the interrupt on-change flag. This will just
end the miss-match condition, which then allows you to manually clear the flag.

Read the port, then clear the flag, then enter sleep. That may help.

[Archangel]

If GPIO.4 is going high on power-up, it's most likely due to you
not initializing the port latches before writing to the tris register. Port latches are unknown
at power-up so it's a good idea to set the port to whatever you want 1st then write to the
tris register.

I.E. GPIO = 0 followed by TRISIO = whatever. Then you know the pins that are outputs will
be at a certain logic level at POR.

That is really good to know, logic would seem to indicate the opposite which is to say, It would appear that you would set I/O so as to know if ports are outputs or not.<b> YOUR explanation makes good sense.</b>. Another tidbit for your book?
Thanks for that BRUCE,
JS

[macinug]

Thanks Bruce, thanks Joe.S.
The project is now working. I hope this is useful to others too.
It's a good forum.
Cheers
macinug