Hi Dave,
I only use MPLab for programming the chip it isn't used for anything else. The current fuses show up perfectly in MPLab when I import my code into it. If I change them, they change in MPLab with next import. I have also turned off the 'set from code' on import and set them manually, but still no luck.
I suppose I could change MicroCode Studio's setup so that it used MPLabs assembler (I have used it that way before) instead of PBP's and then I could use the fuse settings that you listed. It might be worth a shot. I will check it on Monday.
Either I am missing something really simple or this thing just isn't compiling/programming correctly as far as I can tell. My PICStartPlus programmer has the most current software upgrade too. Monday I'm going to try it all with a different computer and my other PICStartPlus programmer. I also order one of MicroEngineering Labs new programmers along with the PBP upgrade, so I'll see if that makes any difference. My current version of PBP is supposed to work with the F88 though, so I am at a loss.
My current setup is working fine with the other PIC's I am programming and using in other projects, but I need some of the extras in the F88 for another project and I am just not getting anywhere with this bad boy.
Thanks for the suggestions,
Carl
Bookmarks