You've already been given all the information you need during the course of this thread to figure that out for yourself. Go back and read and re-read and re-read and repeat...
Rephrase the sentences above. They aren't making a lot of sense to me...might to somebody else, but the grammar just isn't quite working out...My code runs with internal OSC 8 MHz (I hope) but after leaving the PCB for some hours, it need time to start normal. Reading DS1990A and first time touching the probe nothing happens, second time all O.K - after about 10 sec all works normal and it also works if you touch direct after each other - touching of course allways with different DS1990A and after each reading the variable holding the code resets.
The way I read it...The program runs, then it stops, then you touch something, it runs, restart it, doesn't want to restart, but will after a few seconds, then the code resets?
Bookmarks