Config problem PIC16F886

[Bosse]

Hi skimask,

Thank you very much for all your help, now I will change the config in the INC file.

Wish you all the best

Bosse

[Archangel]

Hi skimask,

Thank you very much for all your help, now I will change the config in the INC file.

Wish you all the best

Bosse

Ya Know, I would only add an <b><font color=red> ; </b></font color> there. What I would do is save the configs you want saved as a file, call it 16F886 Setup and open it for each new project, then when you get ready to compile just save it as your new project's name: MyNewProject.BAS

[Bosse]

Hi Joe,

Thank you for your help. Was working yesterday to 06.30 in the morning, so today I have not tried out the new settings. Will do it tomorrow and belive it will work now. Have tried with LEDs and sometimes 2 LEDs lights when only one should. Will send you info about my progress tomorrow.

Many thanks again ALL of you

Bosse

[Bosse]

Hi everybody - especially you how have helped me, MANY THANKS!!

Now it is running nice - still a warning from PicKit2 - Configuration 23EC 0700

But can not see any problem when program runs - have hardtested all functions and NO problem to see.

All the Best to you all

Bosse

[skimask]

Now it is running nice - still a warning from PicKit2 - Configuration 23EC 0700

I think, but I'm not sure...
The datasheet says that the upper 2 bits of the CONFIG1 register should read as 1's (even though they're not used), and the same thing for most of CONFIG2.
This leads me to believe that your config word should be $E3ECFFFF when read back off the chip.

Have you got the latest versions of MPLAB, PICKIT2 firmware and software loaded up?

[Bosse]

Hi,

Yes, have MPLAB Ver. 8.00.00.00 and updated PicKit2

Shall read bak and see

[skimask]

Hi,

Yes, have MPLAB Ver. 8.00.00.00 and updated PicKit2

Shall read bak and see

MPLAB is up to 8.14.
PicKit2...check the website for the latest.