Config problem PIC16F886

Results 1 to 40 of 56

Threaded View

  1. - 9th September 2008, 20:27 #27
    skimask's Avatar
    skimask Guest

    Did you find this post helpful? Yes | No

    Default

    Quote Originally Posted by Bosse View Post
    @ __CONFIG _CONFIG1, _INTOSCIO & _WDT_ON & _PWRTE_ON &_MCLRE_ON & _LVP_OFF & _CPD_OFF & _FCMEN_OFF & _IESO_OFF
    Anything below this line isn't going to have an effect on your CONFIG fuses.
    They are 2 separate entities...
    And when I said read back, I meant the actual config word data as read back using the PICKIT2, not the data you are trying to push out to the PIC using the programmer.

    EDIT: Just checked your CONFIG against the '886/887 datasheet. When reading back the PIC after programming the config word, you should readback $E3ECFFFF, if it's actually being programmed to those values.
    Last edited by skimask; - 9th September 2008 at 20:54.
« Previous Thread | Next Thread »

Similar Threads

  1. A/D conversion with PIC18F67J50
    By ScaleRobotics in forum mel PIC BASIC Pro
    Replies: 9
    Last Post: - 8th May 2009, 01:48
  2. 18F4550 Bootloader enter via eeprom setting
    By bradb in forum mel PIC BASIC Pro
    Replies: 3
    Last Post: - 22nd November 2008, 23:51
  3. Error 0X0000008E when connecting a 18F2550 USB HID
    By FranciscoMartin in forum USB
    Replies: 8
    Last Post: - 16th October 2008, 17:20
  4. PortE problems (PIC18F4455)
    By RubenR in forum mel PIC BASIC Pro
    Replies: 15
    Last Post: - 12th July 2006, 15:26
  5. Installation sequence
    By Demon in forum General
    Replies: 23
    Last Post: - 11th July 2006, 03:56

Members who have read this thread : 0

You do not have permission to view the list of names.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules