Hi All,
I have found the code below on the Rentron for Infrared Serial Communication;
<code>' Initialize hardware PWM - IRLED 40KHz drive
PORTB = %00000000 ' PortB = 0 : IRLED On PortB.1 Off
TRISB = %00000000 ' PortB = all outputs
CCPR1L = 62 ' Set PWM Duty-Cycle to 50%
PR2 = 124 ' Set PWM for 40KHz
CCP1CON = %00001100 ' Mode select = PWM
T2CON = %00000100 ' %00000100 = TMR2 ON 1:1 pre-scale</code>
How would i go about changing this to 50% Duty-Cycle at 38Khz?
Thanks,
Jeremy
Bookmarks