noise my friend, seems the only option at this stage.
|
noise my friend, seems the only option at this stage.
|
or your display is messed up. Checked the leads into the display?
Just out of curiosity, what is the rating on the tranny? and what was the total current draw on the circuit?
|
And once again, it sounds like it's time to go back to the drawing board with a 'blinky led'...
Yes I know it supposedly works fine on the '887 demo board, that's great.
Add an LED to the 877A board and get that working, then build back up to a clone of the 887 demo board.
|
Guys,
Everything is working perfect when I use the programmer power.
A ~700 lines code.
The problem is very simple when connecting outside power source.
|
I build a temporary new board and it works ok.
Maybe something is wrong with the other board.
I might build it fro scratch again.
Thanks.
|
Does it run if you manually RESET (pull MCLR to ground) it after power up?Originally Posted by menta
If so, put a capacitor across MCLR and ground, and a resistor between Vdd and MCLR.
The problem might be that MCLR is coming up faster than Vdd.
An R/C across MCLR might slow it up just enough to meet the chip's MCLR timings.
|
On the temporary board the led was blinking very fast (suppose to have 1 sec pause)
Only when I set MCLR to +5v it started to run ok.
|
Sounds like bad soldering or bad connections. Glad you have it sorted though. External power source making it work points to sever current loss accross your tranny/7805 circuit. Could it be your bridge rectifier is shot in the tranny? low power output?
|
The LED was probably dumping your +5v line repeatedly causing a brown out causing your PIC to reset making it look like it was blinking really fast (which it probably was). If your MCLR was floating (i.e. not connected), same thing may happen (i.e. brown out triggers MCLR just by chance). Connecting MCLR to Vdd might've help alleviate the situation, but sounds to me like a temporary fix.
Not a good practice to leave MCLR floating, unless you are absolutely sure it's tied internally (which I'm not sure the 16F877A has that exact option).
Add an extra resistor inline with your LED (make it really dim), pull the +5v off of MCLR and see what happens (less current flow across the LED, less load on the main +5v rail, etc).
Then maybe try adding another capacitor between Vdd and Vss...can never have too much of that...
|
Never mind
|
Dammit!!!! Didn't spot the MCLR pin wasn't connected in the schematic. Maybe need new glasses!!!!!!
|
Well, I really dont know what do more.
On the test board everything was ok. The LED was blinking, the LCD shows the numbers.
Now I wrap it again and it aint work, unless I touch the 8Mhz crystal with my hand ;-0
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks