Yes Joe that is a typo in the copy and paste. When I read all the replies with example code how are ya'll inserting the code block whereas I am just copying and pasting my code to this reply. I am assuming, which I don't like to do, that under additional options I could attach my questionable code.
What does the DEC mean and do? In the manual I understand it to be Decimal as in MYDATA would be recieved as a decimal. After reading many post on Manchester, I would think I would only be using Binary, but it would seem in the end Binary, Decimal and Hex would all be the same.
loop1:
SERIN2 PortA.1,84,[DEC address1,DEC ADDRESS2,DEC MYDATA1,DEC MYDATA2]
Return
end
Sayzer, in the flip/flop method you are speaking of, I can see how to turn an output on/off with the toggle command, but I do not understand how I could press the button on the tx and the output would come on the receiver but would have to release the button and press again to make it go off. As I have it using the toggle command as long as I am pressing the button on the tx the rx output just cycles on and off. Well I will keep reading the PBP manual maybe thats in there and I have missed it. By the way I am using the PBP v2.50 with the update installed.
Many, many thanks to all for your help and patience.
Bookmarks