Generating 3-phase sine wave..

[skimask]

Yes, it DO (does) reset...

I set portd.0 to toggle on timer1 interrupt and it's been working fine.. (4.2Khz)..(i didnt get rid of those stuffs)

Then I set portd.0 to toggle inside the (if Flag = 1 then...) and it's been toggling in a frequency of 900Hz... It should be also 4Khz....

Well, any idea?

Thanks!

Are those GOSUBs and LOOKUPs still inside the Flag=1 If/Then block?

[sirvo]

I've measured the frequency of the block (if flag = 1 then) with and without the GOSUB/LOOKUP table.. it remains still ~900Hz...

I was thinking about the HPWM frequency generated by Timer2.. Its frequency is ~100Khz ..
Should not it be the problem? Well, I changed it to 20Khz and still got 900Hz...



Thanks...