Question about 18F4450

[manwolf]

Darrel
No I didn't know that, I have been using the MSSP pins and figured that was the way it had to be.
The code I have written works on the 877A and 887 but not on the 4450. I am reading and writting to EEPROM.

I am currently using this to set the ports. (LAB-X1 board)

DataPin var PORTC.4
ClkPin var PORTC.3

I inserted the 4450 and programmed it, everything worked except the writting to EEPROM.

Guess I should have looked a little more closely at the datasheets. Pins changed in 4450, so no I2C on LAB-X1 Board.

877a - Pin18 - SCL - c3
Pin23 - SDA - c4

4450 - Pin18 - Vusb - Input
Pin23 - c4

Waiting for a few remaining parts to be able to start using Breadboard, then I can get off of the hardwired ports on the LAB-X1.

Thanks for your timely help there Darrel.