PIC16F887 and DS1307

[skimask]

Found it

What happens if CounterA = $EC?

[Melanie]

We're talking about a DS1307 RTC here (and ignoring the MSB of certain Registers) where the only valid individual digits are in the range 0-9. The subroutine converts two digit DECIMAL in the range 0-99 to a single BCD Byte. $EC is not a valid conversion requirement for this application.

[skimask]

$EC is not a valid conversion requirement for this application.

My point was that there isn't any sort of error checking, flipped bits, logic errors, and so on...

[crisxstyle]

Hi!!!
I just wan't to know if its possible how i can set manualy the initial time of the clock using a bic basic code!i tried to do it but i found some problems due to bcd and hex code!
so there someone that do it?!?!

thank you so much

bye bye Cris

[skimask]

Hi!!!
I just wan't to know if its possible how i can set manualy the initial time of the clock using a bic basic code!i tried to do it but i found some problems due to bcd and hex code!
so there someone that do it?!?!

96 hits on these forums alone for ds1307...
Surely there's something in one of those threads to help you out...