Newbie needs help

[skimask]

And I want to interrupt this loop with a button push, more importantly a button hold, (2sec). So when you hold the button it pops out of its loop.
Don't really know where to start with this... as far as I can tell I can only check the button state (up/dn) once per loop?
Thanks for your patience..

Then don't do one 10-second pause, do 5 2-second pauses....
Or 10 1-second pauses. If the button is held for 2 consecutive pauses, then kick out of the loop.

[chien_fu]

Hot damn! That was quick thinkin! You just blew my mind...
hehe, thanks dude!
Is that common practice? Or would interrupts be used for something like that ever?

[skimask]

Is that common practice? Or would interrupts be used for something like that ever?

Totally your call...

[chien_fu]

Next question...
I'm trying to generate a random number between X and Y...
The only command I see is:

Random Var

And the manual says it generates numbers up to 65,000

Is there a way to reign this bugger in a bit?

[skimask]

Next question...
I'm trying to generate a random number between X and Y...
The only command I see is:
Random Var
And the manual says it generates numbers up to 65,000
Is there a way to reign this bugger in a bit?

Turn on your outside the box thinking...

If the number is too big, don't use it.
If the number is too small, don't use it.
If the number is below the lower limit of what you want, or above the upper limit of what you want, then DON'T USE IT.

[chien_fu]

That's what I've got going now...

Randomizer:
RANDOM rand
high 3 : pause 10 'Blinks an LED once per random number generated
low 3 : pause 10
IF rand > 100 THEN Randomizer
IF rand < 1 THEN Randomizer


but the "random" numbers just seem to get larger and larger. After rand > 100 it just goes into a vicious blinking cycle, never to return.

[skimask]

That's what I've got going now...
Randomizer:
RANDOM rand
high 3 : pause 10 'Blinks an LED once per random number generated
low 3 : pause 10
IF rand > 100 THEN Randomizer
IF rand < 1 THEN Randomizer
but the "random" numbers just seem to get larger and larger. After rand > 100 it just goes into a vicious blinking cycle, never to return.

What does your manual say about random, specifically the last sentence in the section about RANDOM?
And what is the answer to 65535/655 ?
Can you do anything at all with that?