LCDOut Woes

[LetTheSmokeOut]

I see no LCD defines in your code... please put them in.

They are in the PICBASIC manual and tons of examples on this forum. Set them up for the way you've got your LCD wired.

Yes, contrast works on three different (brand new) LCD's. All LCD defines are now at default which is:

PORTA.0 =Data bit 4
PORTA.1=Data bit 5
PORTA.2=Data bit 6
PORTA.3=Data bit 7
PORTA.4=R/S
PORTB.3=Enable
R/W is grounded

I Disabled MCLR to eliminate the need for pull-up and hassle. I also tried TRISA=%00000000 and TRISB=%00000000. I will post anything you need. Pictures, or anything else. I can even switch to a breadboard and eliminate possibility of circuit board issues (proto board) although I have spent literally 20 hours soldering and de-soldering an looking at every little solder joint, then using PWM and other commands to make sure the chips are good and working properly.

Thanks for your help on this. Very, very much appreciated...