PicBasicPro+MicroCode studio plus and ICD debugging

[michel]

To be sure...on that drawing from microcode...that DB9 shematic is female configuration...is it?

If so...I used a male and pins are upside down

Michel

[Bruce]

Before you can get ICD working you need to make sure you have a good serial connection.
If you can send/receive serial data between the PIC & PC it should work fine with the ICD.

If not, then you'll need to fix that first.

[michel]

Connection are good on serial!


I can get the 628 to blink led without connecting to max232 with that code....

' Example program to blink an LED connected to PORTA.0 about
' once a second
'DEFINE LOADER_USED 1
'DEFINE OSC 4
trisA.0 = 0


x var byte
led var porta.0


loop:
x=1 ' Turn on LED connected to PORTB.0
led=x
Pause 500 ' Delay for .5 seconds

x=0 ' Turn on LED connected to PORTB.0
led=x ' Turn off LED connected to PORTB.0
Pause 500 ' Delay for .5 seconds

Goto loop ' Go back to loop and blink LED forever
End

To get RX and TX working on 628 should i put line in code to get it to send and receive or ICD complile does it for me....

[michel]

I do select the right COM to run program....witch is COM9 for me....is a PCMCIA card to RS232.

[michel]

Desktop image of MicroCode ERROR

[skimask]

Desktop image of MicroCode ERROR

Looks to me like the fix for your problem is right there in the error message...

[michel]

Bruce told me that I don't need DEFINE LOADER_USED 1. I have tried it with it an doesn't work.

Is the led supposse to blink when programmed with ICD complile and program?

Tanks again...