Wrong forum?? Question about microcode

[muddy0409]

Hi everyone.
I am using micro code studio 3.0.0.5 and have a bit of a problem:
When I print my code, it prints all scrunched up as if it is trying to print each line in 2 thirds of a paper width and this makes it non readable. Print Preview on screen also does the same thing.
It is almost as if there needs to be some adjustment of the margins, but there isn't anywhere to do this.
I have played with the EDITOR OPTIONS but cannot cure the problem.
The printer works perfectly on every other programme I use.
Any suggestions, (apart from nick off to the correct forum)?

[mackrackit]

What OS are you using? Sometimes Linux will do that printing through wine. If that is the case, just copy paste to Emacs or something and print from there.

[Acetronics2]

Hi, Peter

is your Editor right gutter set properly ??? ( default is 80 ) ... this could be a very good reason !

VIEW\Editor Options\general tab ...

Alain