Serial VB 2005 pic 16f877a problems

[Snap]

first I tried substatuting some of yor lines of code into my program for mine like...
serIN [WAIT ("OK"), DEC pcsig] insted of
DEBUGIN [WAIT ("OK"), DEC pcsig]
and i added the
portc=0
trisc=0
HIGH PORTD.3 ' Serial OUT idle state
pause 500
at the beginning
but it stilll locked up at the exact same spot.
So I started a new project and used your code exactly
I recieved the
Error[118] C:\PBP\SAMPLES\BLINK.ASM 122 : Overwriting previous address contents (2007)
Error[118] C:\PBP\SAMPLES\BLINK.ASM 122 : Overwriting previous address contents (2007)
when i compiled but programmed it anyway
it now locks up at
Temp=0
and will not move at all
and the vb still cant open the port because it is locked (just like always)
Sorry i can't get it to work, i am at a total brick wall on this one.

[mister_e]

use it as is, paste my own first.. even better, try at 9600 bauds.. that's what i've used yesterday.

For the error message refer to post #5 at the following...

http://www.picbasic.co.uk/forum/showthread.php?t=543

[Snap]

fixed the error messages but it still locks up after the temp= 0 lcdout
and the vb program still can't open the port because of it
sorry again i think it's time to give up for a while, i don't want to take up any more of your time. I will add to the post if I get it going.
Thanks again to everybody.
I can't believe such a simple thing as a serinn(now a debug) is causing such a problem.
Snap