dsPIC30F2010

[dome.viola]

This is my first message in this fantastic forum, i have a problem with my pic30f2010.
I use this pic as a A/D converter, i have load on the pic an old code (because i have problem with C ) so the pic transmit and recive the signal without any problems but when i enter a voltage it recognise the value and has an increase but after a few second return with it standard value (30-40mV) and i think that without a change of voltage the pic must transmit the value in entry, for example 4volt and not return on 30-40mV!!!!

Moreover when doesn't entry any voltage (0 volt at entry) the pic transmit a noise of 30-40 mV.

The problems is in the code or in my circuit??

Please help me...

I can send a scheme of my circuit and code in C if necessary...

Thanks.

[skimask]

This is my first message in this fantastic forum, i have a problem with my pic30f2010.

I didn't know PBP supported the dsPIC series! When did this happen?
Somebody send me the link for the upgrade. I want it NOW!

I can send a scheme of my circuit and code in C if necessary

And PicBasic and C are compatible now?
Has something happened since I last checked the website?

[mister_e]

Hi,
there's some user here using DsPic, unfortunately here it's for Melabs PICBasic PRo compiler.. which don't support any DsPIC. I would suggest you to go on the MicroChip Forum.

http://forum.microchip.com/

Could be a code problem...

[skimask]

Could be a code problem...

Could be a circuit problem...

[dome.viola]

thanks for the help... i am going now on a microchipforum...

Bye bye

[mister_e]

See ya over there

HINT: always post your circuit and code on that forum.