Try this:
Code:
DEFINE OSC 8
DEFINE LCD_DREG PORTB ' portb is the port used for data lines
DEFINE LCD_DBIT 4		'the pin on port connected to LCD pin DB4
DEFINE LCD_RSREG PORTA	'pic port used for the RS line
DEFINE LCD_RSBIT 4		' port pin where RS pin is connected
DEFINE LCD_EREG PORTB	' PIC port where E pin is connected
DEFINE LCD_EBIT 3		' port pin where E pin is connected
DEFINE LCD_BITS 4		' 4 bit mode
DEFINE LCD_LINES 2		' 2 LCD lines
DEFINE LCD_COMMANDUS 2000	'delay between LCD commands
DEFINE LCD_DATAUS 50		'delay between data sent
adcon1=7:trisb=0:trisa=0:intcon2.7=0:osccon=$70
PAUSE 1000
repeta:
high portb.0:LCDOUT $fe,1,$fe,2, "hello":pause 1000:goto repeta