Measuring voltage from a current transformer

[docwisdom]

Loads will be anything that can be plugged into a 120v plug.
Most common will be lights, heaters, computers, other electronics, etc.

whats the difference between a precision rectifier and a full wave bridge rectifier? lemme guess, precision ..heh

last thing. I am good at getting things done once I have a detailed parts list. The circuit explains what what kind of resistors and op amps to use, but no specs on the diodes. Digikey carries ~10,000 varieties.

[Darrel Taylor]

Loads will be anything that can be plugged into a 120v plug.
Most common will be lights, heaters, computers, other electronics, etc.

Refrigerators, Sump Pumps, Compressors, Fans ...

They can all be plugged into a 120V outlet. And they would all be considered "Inductive Loads".
So you can forget about the Precision Rectifier.

Check out the datasheet for the LTC1966
At the bottom of the sheet in the "Typical Applications" | Single Supply RMS Current Measurement
Shows exactly what you need.

Added: Although you might want to increase the "Burden" resistor. 4mv/amp is hard to read with a PIC's A/D.
<br>

[dhouston]

Toss the current transformer in the junk bin and get a hall-effect current sensor ffom Allegro Microsystems.

• http://www.allegromicro.com/en/Produ...rentsensor.asp

They have high isolation, handle AC or DC, come in a wide range of current capacities, output a DC voltage proportional to current, and are rather inexpensive.

[docwisdom]

i would, but as i mentioned in previous threads, i need for it to not interfere with the primary path. the hall effect devices require you to break the primary path and route it through the IC.

DT, just to satisfy my natural curiosity. what effect will you experience if you were to have an inductive load on the primary with a precision rectifier on the secondary?

[Darrel Taylor]

what effect will you experience if you were to have an inductive load on the primary with a precision rectifier on the secondary?

You would get the wrong amperage reading.

If you calibrated the device with a resistive load, so that it reads the correct current with light bulbs etc. When you plug in an inductive load like a motor, the readings will be much lower than they should be. They will vary from one inductive load to the next. And even the same load at different current levels will be in error by different amounts.

If you plug in a Light Dimmer, Motor Soft-Start or speed control, The thing will go absolutely NUTS from the "Chopping" of the SCR or Triac.

All of those problems are resolved by using the RMS converter. Which gives the correct amperage under ALL conditions.
<br>

[docwisdom]

Cool,
Ill give the RMS converter a shot.

-edit-
seems LTC1966 is discontinued.
found this http://search.digikey.com/scripts/Dk...me=AD736JNZ-ND

[Darrel Taylor]

seems LTC1966 is discontinued.

Hmmm, well that's unfortunate.
I really liked that chip.

I'm sure any other "True RMS to DC" converter will do just as well. It's the RMS that counts.
<br>