pic12F683 , gpio.5 not accessible...

[Jumper]

http://forum.microchip.com/tm.aspx?m...%2cMCLRᾬ
http://forum.microchip.com/tm.aspx?m...2cMCLR&#204739


this might explain why.... but as they say. If you power your PIC from the ICD2 and don't load it too much it might work anyway. And to get rid of this warning just use an older version on MPLAB.

/me

[flipper_md]

uhh, so steppin back in old version of MPlab would make it work fine... funny

thanks for digging that out!

[flipper_md]

Well, I have tried both MPlab 7.40 and 7.20 , and still get the warning 33 about using both Osc/master clr internal

The chip seems to take some hit when trying to force programming.
I have to erase it a couple times when I see a verify error, then it seems to work ok :O

So I assume I have to let go one pin away...


But now I got and little funny part to play with! Heart rate monitor chip strait from the maker, Polar. Got to find how to use the signal :P