H bridge

[skimask]

I am looking for a H-bridge circuit to control a 12 VDC motor with a 10 amp draw.
I have used a TIP 120 circuit in the past, but I think it is limited to 5 amps max.
Any suggestions?

Google....248,000 hits on the first try....
Without looking at the datasheets (which again, is just a single Google search away), a TIP120 handles 5 amps according to you, you need to draw 10 amps. How about a simple paralleling setup with emitter ballast resistors....
Then there's the whole heatsinking issue...