thermometer and humidity sms

[elektoro2009]

Do yuo know sample temparature and humidity sms send circuit.
Could you write sample address.
I know this address: http://www.wrankl.de/SMST4PIC/SMST4PIC.html
I maked this circuit,but complate not run.Don't sms.
Thank you.Regards.

[Ioannis]

Hi! Please read my post again. What you are trying to do is a complicated project. Not for the novice. If you insist on doing it, then do it with small steps, one task at a time.

1. Select your mobile device. READ CAREFULLY the Data Sheet and get acquainted with it.

2. Use only the USART of your PIC (you need of course level translation like a MAX232).

3. Try to communicate with your mobile device with simple commands like AT and wait for the answer OK.

4. Then try more complicated tasks like sending SMS.

Also note that some commands like deleting SMS might take some time until they respond with OK. Not all commands execute immediatly!

Ioannis

[skimask]

If you insist on doing it, then do it with small steps, one task at a time.

I'm probably guessing here, but....

Step 1.1 - Make blinky LED

[Ioannis]

It is a good idea if he has not blink a LED up to this moment, but I did not meant so small steps!

On the other hand, a good schematic, a BOM and the full program, debuged, is most welcome.

Ioannis

[skimask]

It is a good idea if he has not blink a LED up to this moment, but I did not meant so small steps!
On the other hand, a good schematic, a BOM and the full program, debuged, is most welcome.
Ioannis

Ok, how about this:
Step 1.5 - make blinky LED?

Look at all the posts... He's all about 'sample software' and 'sample schematics'. Sounds to me like it's all about 'samples' and not designing and creating.

[Ioannis]

...
Sounds to me like it's all about 'samples' and not designing and creating.

OK, then: http://www.samples.com/

Ioannis