SLEEP, WDT and INT

[mackrackit]

Nap might be more of what you want.
From the manual

NAP puts the processor to sleep for one Watchdog Timer period. If the
Watchdog Timer is not enabled, the processor will sleep forever or until
an enabled interrupt or reset is received

Turn the WDT off in the config and the PIC should be in a low power mode until the interrupt occurs.

[xnihilo]

From PBP pro manual:

Places the microcontroller into low power mode for short periods of time. During this NAP, power consumption is reduced to minimum. The listed periods are only approximate because the timing is derived from the Watchdog Timer which is R/C driven and can vary greatly from chip to chip and over temperature. Since NAP uses the Watchdog Timer, its timing is independent of the oscillator frequency.

It seems it needs WDT.
Moreover, the right way to use this, according to PBP, it's to define a period.

I don't want to use WDT and I don't want to set period. I would like to put the PIC into low power sleep until an int awakes it...

[Darrel Taylor]

Sure, just turn off the WDT in the configs.

Then when you put it to sleep, it will stay that way until an interrupt is triggered.

You can use ...

@  SLEEP

and you won't need to enter a period.
<br>

[xnihilo]

Sure, just turn off the WDT in the configs.

Then when you put it to sleep, it will stay that way until an interrupt is triggered.

You can use ...

@  SLEEP

and you won't need to enter a period.
<br>

Do I need to use
@ sleep
?
With PBP, can I use something like:

loop:
sleep
goto loop

?

(I always disable WDT in the config words).

[mister_e]

Yes you can do something like that... but the assembler line @ sleep will send your PIC in sleep mode forever... or 'till an interrupt happen. PBP SLEEP will send your PIC in sleep mode for a x period of time and then wake up. It's really up to you. I prefer the @ SLEEP

[xnihilo]

Yes you can do something like that... but the assembler line @ sleep will send your PIC in sleep mode forever... or 'till an interrupt happen. PBP SLEEP will send your PIC in sleep mode for a x period of time and then wake up. It's really up to you. I prefer the @ SLEEP

Thanks you all.

So I can use something like:


ON INTERRUPT GOTO myinthandler

start:
@ sleep


myinthandler:
...

In this case my main program is only the @sleep instruction and once the int has been processed, it goes back to sleep until next interrupt, is that right?

[mackrackit]

Yes, that should work.
This thread has some good info of the ins and outs
http://www.picbasic.co.uk/forum/show...ighlight=sleep
Read post #3