Dear all.

first off all i would like to apologise my bad english.
Iam been working a robot project control via serial com PC using 4 channel RF( thanks to melaine that give source code on this forum). Transmitter section, iam using PIC 16F626 and to control 4 (led) output RA.0 to RA.3 that i connected to Transmitter module (4 ch).
On Reciever section, Reciever module is connected to PIC16F877 RB.0 to RB.3.
10 Output(led) is connected to RA.0 to RC.2
The problem is how to control the 10 LED individually using only 4 input?
i hope that this imformation can inderstand my project situation
regards

cibotsan