rfPIC Project without using the dev board

[Destovi]

I am not using a dev board, just breadboarding the two PICs and wiring in the components I will be using the pic kit programmer with mp lab. I don't need a complex design. all I want to do is transmit data like 1 meter and be able to detect when the data has been successfully transmitted.

[mackrackit]

OK, I think I got it. You want to make your own circuit board, soldered together and put in a box.

If this is correct let us know. I do not want to post a how to and not answer your question.

[Destovi]

yes I think you got it, I have all the components, resistors, wires, and everything and I want to wire up the circuit myself, I have the rfPIC and RXD receiver as well as different PIC micros if they are needed. Once I have made the circuits I want to program them to send data from the rfPIC to the RXD and when it is received I want to turn on a led, once this led is turned on I can figure out how to attach that rxd output pin to the microprocessor and do whatever else I need. I am just a bit confused on the circuits and programming needed to do this.

thank you very much for your time in helping me out with this project.

[mackrackit]

Start off by reading this and I will see if I can find some more info latter.

http://www.microchip.com/Stellent/id...pnote=en012044

[Destovi]

thank you very much for this Dave I thought I had looked at everything on microchips site but I missed this. Appendix A is very helpful as for the transmitter device. also as I dont need the pressure sensing part or the LF part this will be a very small circuit which is great.
I am very greatful for this information, if you have some time and can assist on the receiving end (RXD) or the code as well that would be great.

Thanks again

[mackrackit]

I think at this point you would benefit from getting the CD from Bruce.
http://www.rentron.com/QRELAY.htm
I do not have it , but if it is like Bruce's other stuff it should get you going and then some.

Should save you time and headaches.

Then when you have a specific problem you will be able to get direct answers.
Now we are going with general questions that will take forever on the forum.

But I have a question for you. What other projects have you done. This is a tough one to start with if you do not have much experience.

[Destovi]

I am in my graduate year of electrical engineering and am just wanting to try to do some rf work on the side. I have no problem building the circuits, I have just not programmed the rfPIC or the RXD so I was just hoping to get some assistance with the code needed to program both.