PICBasic newbie problem

[ELCouz]

Dear members,

FOA,I'm not new to the PIC World, I'm using CCS C compiler regularly

Recently I started using PICBasic Pro because i knew basic is easy to use when it come create very simple project... you know leds stuff!

However after reading that @ __config is depreciated for PIC18
I'm trying to use CONFIG instead but how ?

CONFIG FOSC = HS,LVP = OFF,BOR = OFF,MCLRE = OFF

led VAR PORTB.5
steps VAR WORD
cycles CON 2

' Change limits for steps to play around 0 or 100% brightness
' Change steps for different duration of ramps
' Works good even with high brightness LEDs, harder to control linearly


fade:

up:
For steps=0 TO 255
PWM led,steps,cycles
Next
High led

Pause 2500

down:
For steps=255 TO 1 STEP -1
PWM led,steps,cycles
Next
Low led

Pause 2500


GoTo fade

End

Microcode studio says ERROR syntax at the first line! why ?

Yes i did read the other post, including the faq about headers but like i said __CONFIG dont work anymore with MPASM

Best Regards,

Laurent

EDIT: oh btw , pic18f4550 with 12mhz hs xtal