Hi Everyone,

I purchased an EPIC programmer some time ago and finally got around to try to program today.
But I'm stuck at the "Epic programmer not found" message.

I don't think it can be the cable. The LED remains lit until I actually try to program the 16f876.
I've removed my HP printer driver and set the parallel port to ECP in bios.( as instructed by MELabs)
I've installed a Generic printer driver and set it to default.

And yet, and yet. It can't find the EPIC programmer.
I've rebooted until my thumb is raw.
I was really hoping to start making dream machines today. And suggestions?

Cheers
MacQ