Open the PK2CMD.txt file, then use this one
/PPIC$target-device$ /f$hex-filename$ /E /M /Y /R /H2
about now?
|
Open the PK2CMD.txt file, then use this one
/PPIC$target-device$ /f$hex-filename$ /E /M /Y /R /H2
about now?
Steve
It's not a bug, it's a random feature.
There's no problem, only learning opportunities.
|
Thanks Mr.E, I just tried that, but the problem is still there.
I also tried to program the board with external power on and power off, it seems that PICKIT2 does not release the control after programming, so nothing happen if I push reset button on mclr pin or when the power is turned off then back on
|
It works here... can you post your schematic, code and PIC#?
Steve
It's not a bug, it's a random feature.
There's no problem, only learning opportunities.
|
My program , schematic & circuit board are okay, I can program it directly with Pickit2 Programmer (MCS -> Compile to hex (F9) -> Pickit2 Programmer software -> Pickit 2 ), with no problem at all.
Other thing is that I cannot calibrate Pickit2 , it says it cannot fully calibrate the unit, the USB voltage is too low. Could it be the problem ?
|
Go to Microchip Support:
http://support.microchip.com/scripts...=webticketcust
They will fix your problem.
|
Well, it seems that it is the "bug" that microchip has to address . It is also mentioned in Nuts/Volt magazine January 2008 page 69
|
what firmware you use for Pickit2? if you can download and use latest from MPLAB8.01 , perhaps you may find a fixed version? similarly do you use pickit2v2.4 software for the PICkit driver?Originally Posted by luminas
Regards,
Sarma
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks