how to shrink code

[Peter1960]

a minor oversight !
The demo PIC had 8k,
final PIC ONLY 4k !
Suggestions to shrink code, please !
I have already used ASM/ENDASM where possible,
have used minimal GoSubs,
I started with 7996 and am down to 5100, only 1100 bytes to go !
any other suggestions ?

kindest regards

[Jerson]

have used minimal GoSubs,

Try re-using code fragments by making them subroutines. Use either Gosub or call depending on whether you call from PBP or ASM section of your code

JF

[skimask]

a minor oversight !
The demo PIC had 8k,
final PIC ONLY 4k !
Suggestions to shrink code, please !
I have already used ASM/ENDASM where possible,
have used minimal GoSubs,
I started with 7996 and am down to 5100, only 1100 bytes to go !
any other suggestions ?
kindest regards

Which PIC?
If it's a 16F series, you can probably mess with the variables a bit.
Figure out which variable you 'access' the most and ensure it's forced into BANK 0.

For that matter, let's see the code.
You'll probably get a 1000 ideas on how to shrink the code.

[sayzer]

Also,
1. If you have small subroutines and/or small loops , keep them at the beginning.

Also,
2. if you are comparing a byte variable to a word variable, make sure, you compare the byte variable to the lowbyte of the word variable.

Ex:
A var byte
B var word

Instead of
IF A = B THEN Home

use,

IF A = B.LowByte THEN Home

Also,
3. If you have HIGH and LOW commands, make them direct access to PORT register.

Ex:
Instead of
HIGH PinA

Use,
PinA = 1


=================

[paul borgmeier]

See Cliff Griffin's hints here
http://www.rcfaq.com/PIC/optimize.htm

[tenaja]

If minimal code size is the goal, then PBP is a LOT of work.

Reducing gosubs is not always the best rule, unless you are getting rid of the subs that were only added to make the code more "readable". If you can insert a few subroutines to eliminate duplicate code, they are very helpful.

One thing to do is eliminate as many built-in basic commands as possible. For instance, hserout is very inefficient. You can manually load your values into the TXreg and save a lot of space. The ADCIN command is probably even worse.

[Peter1960]

Hi and thanks everyone.

Using a combination of Lookup and assembler

the code is now 3768 !!!! beauty !

I noticed that lookup can reduce code but can also
increase code, so be carefull !

thanks

kind regards

Peter