16F872 and LCD

[Fredrick]

I dont know what i have done but now the display shows "333333333333333" on both lines and some times the temerature shows on diffrent positions in the display whit "3" all over the display.

The display is an HD44780 OLED, can the display be broken?

The PBP Hello World sampel works..

[skimask]

I dont know what i have done but now the display shows "333333333333333" on both lines and some times the temerature shows on diffrent positions in the display whit "3" all over the display.
The display is an HD44780 OLED, can the display be broken?
The PBP Hello World sampel works..

I'm sure the 'Hello World' sample works just fine, but when you start messing around with some of the special LCD commands and stuff, the LCD timing starts to matter.
Did you change the LCD_DATAUS yet?

[Fredrick]

Yes i have.

[skimask]

Give this a shot:

@ DEVICE PIC16F872, HS_OSC, WDT_OFF, PWRT_ON, LVP_OFF, PROTECT_OFF
DEFINE OSC 20
DEFINE LCD_COMMANDUS 3000
DEFINE LCD_DATAUS 250
temperature var word : count_remain var byte : count_per_c var byte
dq var portb.2 : ADCON1 = 7 : pause 1000 : lcdout $fe , 1
mainloop: OWOut DQ , 1 , [ $CC , $44 ]
waitloop: OWIn DQ, 4, [count_remain]	 : If count_remain = 0 Then waitloop
owout dq, 1, [$cc,$be]
owin dq , 0 , [ temperature.lowbyte , temperature.highbyte , skip 4 , count_remain , count_per_c ]
temperature = ( ( ( temperature >> 1 ) * 100 ) - 25 ) + ( ( ( count_per_c - count_remain ) * 100 ) / count_per_c )
Lcdout $fe , $80 , DEC3 ( temperature / 100 ) , "." , DEC2 temperature, " C"
temperature = ( temperature * / 461 ) + 3200
Lcdout $fe , $c0 , DEC3 ( temperature / 100 ) , "." , DEC2 temperature , " F"
Pause 1000 : goto mainloop

Also, in your original code, you show:
define OSC 20

Put all DEFINE's in upper case. It's a bit weird like that.
Your original code was probably still compiled as if it were for a 4 Mhz oscillator, even though you had 'define OSC 20'.