PIC18F6680 programming

[skimask]

i need to program a PIC18F6680 thats 64 pin quad surface mount. I want to programing with ICSP but im not exzatly sure which pins or how many are needed. I assume i will need a rs232 to ttl converter correct? I really dont want to unsolder this bad boy to program it. Any ideas anyone?

Two words...Not correct...

www.microchip.com - PIC18F6680 datasheets and programming specifications
www.microchip.com - MPLAB, assemblers, etc.
www.microchip.com - PICKIT2 (my preferred programmer IMO, certainly much more than an RS232-TTL converter)
www.melabs.com - PicBasicPro (also, if you don't like the PICKIT2 from www.microchip.com, check out one of MELABS programmers)
www.dictionary.com - spelling and grammar check
www.digikey.com - jumper wire for tapping into Vdd, Vss, PGC, PGD, PGM lines on the '6680, maybe even pick up a soldering iron, some solder, maybe some flux, some small drill bits, and other handy things for modifying a PCB.