here is a picture of the top of the board. its a little fuzzy compared to my other pics, but i was too lazy to go downstairs to get more batteries for my flash.



i should mention that the solder joints are better than they look, and the flux has been cleaned of a little better since that pic was taken.

the power input is on the bottom of this board, then it goes through the switch and to the buck regulator underneath the LCD, and then the inductor is the black thing on the right. i ordered the wrong ones, when i built this, so i do have smaller, lighter ones now, i jsut havent put them on.

the segments on the lcd that im having problems with, will work sometimes but not others, so i am going to stick the meter on and see what it says.