yeah... . i just dont know about this board...

im in Calgary, and its -42C with the windchill and im workin outside...

Alberta Printed Circuits has a prototyping service that is two boards, double sided with thru-plating... these two boards (the top and bottom were joined together and then i cut it after) were about 3.2" X 2.5", and cost around $36 total... so each board was $13 and there made next day.... its almost not worth it for me to make them....

so i have another board the same as this one, so i might pick up another PIC and try it all again just in case i shorted something or the PIC is bad...

I have no affiliation with apcircuits, but they do good work and they have helped me through design problems so if youre looking for somewhere to make some boards, take a look at them...

eagle cad takes the schematic (which is easy to make and troubleshoot) and makes it into a board, then i email that to apc and then solder it together... there isnt a lot i can do wrong if the design is right, and the soldering is right...