Pic10f206

[mdown]

Thanks for the help. I figured it was something silly like that. I got the fuses figured out and GP3 now functions as an input like I want it to. However the GP2 pin is set by several registers. We disabled CMCON0 so that takes care of COUT, but leaves T0CKI, FOSC4 is set to 0 in the OSCAL0 register so that should be ok. So if I am correct I need to get T0CS=0. Yes?

Thanks again,

Mike

[mister_e]

Yes yes yes

[mdown]

Here is what I am trying do really do with this device:


<code>

@ __config _MCLRE_OFF & _WDT_ON & _CP_OFF

Include "modedefs.bas"

CMCON0=0

SI var GPIO.0 'Define serial in pin
WakePin var GPIO.1 'Define Wake Pin
B0 var byte

start:
low wakepin 'Set the WakePin low
serin SI,N9600,10,start,b0 'Wait for an interval
high wakepin 'Set the WakePin High, we got our interval
B0 = B0 * 60 'Convert the interval to seconds
sleep b0 'Sleep for the interval specified
goto start 'Go to "Start"
</code>

[mister_e]

Bear in mind it's a real nifty PIC, i'll suggest you to use DEBUGIN instead of SERIN. At least @9600 baud with internal OSC, better the chances are to work with DEBUG than SERIN. There's a warning about that in the manual.

I never tried DEBUGIN/SERIN with 10F though...

[mdown]

So I have been trying to get T0CS=0 in the OPTION register but PBP doesn't seem to under stand "OPTION" as a register name.

Any ideas?

[paul borgmeier]

try OPTION_REG instead of OPTION