Wireless problem

[supersonic]

Finally!

At last I've been able to use USART!
On the tx side I changed serout from N2400 to T2400 and the rx started to display correct data! Data is sent 10ms after powering the txer.

99% of data is correctly showed on the display.

Now I have to mount the sensor and send acquired data along with a sort of checksum.

I could stay hours watching the display:0...1...2...3...4..... to see if some of my numbers gets lost. Watching it for a minute, no problems!
So here is the working code for the TX:

INCLUDE "modedefs.bas"

ANSEL=0
CMCON0=%00000111

define osc 4
txpin   var gpio.4
led     var gpio.5
power   var gpio.2
i       var byte

low power

loop:
    for i=0 to 9
      high power
      pause 10
      serout txpin,t2400,[$55,$55,$55,$55,$66,#i]
      low power
      high led
      pause 30
      low led
      pause 1000
    next i
goto loop

And, of course RX:

define  OSC 20
Define 	LCD_LINES	4			' Settings for a 4x20 LCD
Define	LCD_DREG	PORTB		'   4bit mode
Define	LCD_DBIT	4			'
Define	LCD_RSREG	PORTB		
Define	LCD_RSBIT	3		 	
Define	LCD_EREG	PORTB'      
Define	LCD_EBIT	2

DEFINE HSER_RCSTA 90h ' Enable serial port & continuous receive
DEFINE HSER_TXSTA 20h ' Enable transmit, BRGH = 0
DEFine HSER_BAUD 2400
DEFINE HSER_CLROERR 1 ' Clear overflow automatically

'LCD Lines constants
row4        con	$d4
row3	    con	$94
row2	    con	$c0
row1	    con $80
hser var byte

intcon=0

pause 500
lcdout $fe,1
lcdout $fe, row1, "** RX TEST **"

loop:
      hserin [wait($66),hser]
      hserout [#hser]
      lcdout $fe, row3," hser: ",dec1 hser
goto loop