Hi,

I am new here and as well as using VDIP1, I need it for my thesis prototype. I need help on how to reflash the frimware of VDIP1, I did these steps but i don't think something happens

1. I downloaded the latest firmware from vinculum, edit the filename of the file "ftrfb_main_3_68VDAP.ftd" to "ftrfb.ftd"
2. I copied the ftrfb.ftd to the root directory of my flash disk (PQI 512mb).
3. I made the circuit for the VDIP1 module:
3a. pin 1 to VCC (5V)
3b. connected pins 7 and 18 to GND
3c. pin 23 (PROG#) to GND
3d. I connected pin 22 (RESET#) into a reseting circuit that I made, There is a button that when pressed the output is low and when not pressed the output is high.
3e. I remove the jumper pins (both of them)
4. I inserted the flash disk to the VDIP1 module
5. Power the circuit, then press reset circuit to reset the module
6. Nothing happens.

I don't know if it is already reflashed or no, nothing is happening even the LEDs. I already e-mailed vinculum, but i haven't get any response for more than a week now. I really need the help, if you can, can you please give me a step-by-step procedure to reflash the module.

Thanks,
Bogs