X-10 and the proper XOUT statement for 18F2620

[mister_e]

TRISA is nice for safety sake, what i'm talking about is the Analog features (comparator and/or adcs) that might be already enable at POR.

You want to send a digital signal, but it's not going to work pretty well if the I/O is set to analog at POR.

http://ww1.microchip.com/downloads/e...Doc/39626d.pdf

PDF page 226, ADCON1
ADCON1=$0F ' disable all ADCs

PDF page 235&236, CMCON
CMCON = %00000111 ' disable comparator.. yeah even if already disable at POR

PDF page 241 CVRCON
CVRCON = 0

HTH

[JohnP]

Steve,

I see what you mean. I turned off all analog inputs and tried again with no luck. I also tried switching to ports c.2 and c.5 with same result. As soon as the program hits any XOUT command, the PIC apperently resets or jumps back to BEGIN. I have an output message to my LCD before and after the XOUT command. I see the LCD message before the XOUT but never see the LCD message after the XOUT. If I remove the XOUT command, the program proceeds normally.

John P

[mister_e]

post your whole code, configuration fuses and schematic (if possible).

You can try to disable the watchdog timer to see if it solve some part of the problem.

[Nicmus]

Hi JohnP,

I might be wrong , but you need activity on zero crossing pin for the XOUT command to work.
Check out PBP manual page 163 (chapter 5.89 ).
Hope this will help.

Regards,

Nick

[JohnP]

Nick,

BINGO!!!!

I knew it had to be something stupid!! The program waited for the command to finish and the watchdog timer reset the PIC! Disabling the watchdog timer made everything just stop when the XOUT command was executed.

Of course, the real problem was that I didn't read the instructions in detail - I just skimmed and skimmed right past the part about "XOUT will effectively wait forever".

Thanks again for all that replied to my problem. It wasn't a problem, but an opportunity to learn -- from those that knew better.

John P