Chop the legs off the chip as close to the body as possible - leaving as much on the PCB as you can to grab in the next stage. A good pair of flush side cutters should accomplish that. One at a time, heat up each joint and with a pair of long-nose plyers pull the pin out through the top (you should have left enough of the pin in the previous step to grab). Use a standard $5 solder sucker with a half-decent nozzle to SUCK the joint clean... digressing (only slightly) - what I don't understand is why it's called a 'Blow Job'... - but I could be on the wrong forum again....