How much pause should I allow before ( or after) pulsing out a servo command?
How much pause should I allow for an LCD to initialize?

and theoretically, If i were to send a pulse of 160 to servo1 and then immediately after send a pulse to servo1 of 190 , wouldn't the pulse be affected and changed to a pulse that is not 160 or 190?

Also, If I give a pulse of 150 and then clear the output and then give a pulse of 160, wouldn't the pulse given out be messed up?


P.S. I have created working code , but I'm just looking to see the "right" way of doing things.

Thanks,
Eric

I am using a PIC16F616 @ 4 mhz