Use Button For setup

[mister_e]

I would probably suggest to use a button to exit this Setpoint mode, unless you'll need to do everything really fast... which is almost impossible.

Basically, just loop in Setpoint utill a specific button have been pressed Should work. Something like...

SetSetPoint:
        LCDOut $FE,1, "Setpoint at", #SetPoint, "F"

        if Incr = 1 then 'change the setpoint
            pause 100
            SetPoint=SetPoint+1
            if Setpoint>80 then SetPoint=60 'Allow setpoint from 60 to 80
            '
            '
            goto SetSetPoint ' Refresh LCD display
            endif
            
        If YourSpecificButton= NotPressed then goto SetSetPoint

[tump]

Okay I have it working now in ICD mode but not in real life I guess its a timing issue, how would I get into setup as soon as soon as the button is pressed and not having to wait until it is in the loop for setup mode.

[mackrackit]

Use an interrupt. Or inside of every loop have a GOSUB to check the button.

[mister_e]

To me a Timer interrupt is the most valuable and transparent solution.

[tump]

Thanks for the help and I have tried mister_e's suggestion about interrupts

I have tried with the on interrupt with odd results
the program goes into setup mode with the lcd flickering i guess it is due to the
goto setsetpoint to refresh the lcd .

the problem is it will never leave the loop when i press save ( 1 for active 0 inactive)

I noticed by mistake the if i hold down save the program runs again as soon as i let go it stops, I want the save save to be pressed once and resume running the program.

I am guessing that I made an error in the code below but it compiles just fine.

Thanks in advance for any more help.

SetSetPoint:
DISABLE

LCDOut $FE,1, "Setpoint at", #SetPoint, "F"

if Incr = 1 then 'change the setpoint
pause 500
SetPoint=SetPoint+1
if Setpoint>80 then SetPoint=60 'Allow setpoint from 60 to 80

goto SetSetPoint 'refresh LCD with new setpoiont
endif

If Save = 0 then goto SetSetPoint

Resume
ENABLE

[mackrackit]

Try adding

IF Save = 1 then GOTO loop

before

If Save = 0 then goto SetSetPoint

[tump]

Thanks tried your suggestion but still not working.

When save = 1
I want it to exit the loop and resume running the program, am I missing something obvious, or not so obvious since I am new at this ???