Pic12f615 Hpwm???

[mister_e]

oups, i think i didn't check the right datasheet...

something is weird in the CCP1_REG and in CCP1_BIT declaration... So try to add the following defines

DEFINE CCP1_REG GPIO 'Hpwm 1 pin port
DEFINE CCP1_BIT 2 'Hpwm 1 pin bit

EDIT: OUPS again... Bruce beat me. So now, what are those errors ??? Which version are you using?

[WireMan]

I have v. 2.5

I must be missing something... Those defines look the same as the ones above????

Error[113]c:\pbp\pbppic14.lib 1972 : Symbol not previously defined(registername)

[mister_e]

mmm, how about your code? so we can check it here as well.

<hr>

For the other members, you can fix this little problem and modify the 12F615.BAS file located in your PBP folder. Just open it and add the line in RED

BANK0   $0040, $007F
LIBRARY "PBPPIC14"
DEFINE	CCP1_REG GPIO
DEFINE	CCP1_BIT 2

        include "PIC14EXT.BAS"

PORTL   VAR     GPIO
PORTH   VAR     GPIO
TRISL   VAR     TRISIO
TRISH   VAR     TRISIO

        include "PBPPIC14.RAM"

'*-----------------------* EOF 12F615.BAS *---------------------*

This will set the Default settings, and avoid to see that Warning [219] message again.

Thanks Charles from Melabs!

It doesn't explain error [113] of WireMan in the previous post... let's see it's code first

[WireMan]

Here is what I have.....

Duty var Word
DEFINE CCP1_REG GPIO
DEFINE CCP1_BIT 2

TRISIO = %00000000
T2CON = %00010101
PR2 = 249
Duty = 200

HPWM 1,duty,1000

End


On the [113] ERROR it references the following registers...
T2CON, PR2, CCPR1L, CCP1CON

Then there are two registers I don't see in the data sheet...
T2CKPS0 and T2CKPS1

I feel like I'm shooting in the dark here...

[Bruce]

Error 113 is an MPASM assembler error for Symbol not previously defined

This means you either don't have an updated version of MPLAB with the P12F615.INC, it's
bad, it's not being found because your path is not setup right, etc, etc,,.

Set PM as the assembler in MicroCode Studio. If it compiles OK, then you know what the
problem is, and can fix it.

[WireMan]

Bruce,

Thanks!!! For some reason the program got confused as to the path for the assembler. I directed it manually and it is working fine... compiled the first time with no errors!

Thank you to everyone who tried to help with this!!!

Pat