Greetings,
I just got a PIC18F4620 in the mail and tried to program it.
I have the MeLabs U2 USB PIC Programmer attached to the MeLabs 840Z 40-Pin ZIF Adapter
I use MicroCode Studio to write the code in PBasic then I use compile and program. This then does a bunch of stuff and opens meProg. I then click Program and it does its stuff and programs the PIC (wonderful). It has been working great with the PIC16Fxxx's I have been using so far.
When I put the PIC18F4620 (Correct way as per diagram) I get an error message from the meProg. The error message is:
"Error: Target device does not match selected device."
Some Things It is Not:
I have PIC18F4620 in the selection box in both MicroCode Studio and meProg
Seems to complile fine in MicroCode Studio
I can read from the PIC in meProg
Other Information:
If I click Get Target Information in meProg I get the following.
- melabs U2 Programmer
- Firmware version is 4.8.
- Target device ID is FFFF
- Target device does not match selected device.
Anyone have any ideas
Cheers Bruce
Bookmarks