|
Hi, Civic
I have an application with a 452 and LCD on port D ... works fine.
Now, what I see is external interrupts are all on PortB ...
So a special care to the corresponding registers has to be done.
I also use PBP 2.47, but had explicitly ( correct ? ) written all registers ....
Alain
************************************************** ***********************
Why insist on using 32 Bits when you're not even able to deal with the first 8 ones ??? ehhhhhh ...
************************************************** ***********************
IF there is the word "Problem" in your question ...
certainly the answer is " RTFM " or " RTFDataSheet " !!!
*****************************************
|
My 2 cents worth . . .
Here is what I see:
I see no config fuse settings in his code.
I see a circuit board set up to use an oscillator module, not a crystal or resonator, so it would seem necessary to set fuses for External oscillator. Keypad code looks VERY FAMILIAR, like something mr_e once tossed togetherso I am pretty sure it is tested and working. In conclusion, I believe you need to work on your config settings, which should contain statements about _CONFIG1 EC_OSC and WDT_OFF etc . . .
look at this data sheet.
http://ww1.microchip.com/downloads/e...doc/39564b.pdf
If you do not believe in MAGIC, Consider how currency has value simply by printing it, and is then traded for real assets.
.
Gold is the money of kings, silver is the money of gentlemen, barter is the money of peasants - but debt is the money of slaves
.
There simply is no "Happy Spam" If you do it you will disappear from this forum.
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks