Somehow strange... i posted examples of the USBDemo that worked on the following link.
http://www.picbasic.co.uk/forum/show...8&postcount=99

the whole set of config fuses for a 4MHz crystal was
Code:
    '
    '   Pic Configuration
    '   =================
    asm
    __CONFIG    _CONFIG1L, _PLLDIV_1_1L & _CPUDIV_OSC1_PLL2_1L & _USBDIV_2_1L  
                            ;              ;                      ; USB clock source comes from the 96 MHz PLL divided by 2
                            ;              ; [OSC1/OSC2 Src: /1][96 MHz PLL Src: /2]
                            ; No prescale (4 MHz oscillator input drives PLL directly)


    __CONFIG    _CONFIG1H, _FOSC_XTPLL_XT_1H & _FCMEN_OFF_1H & _IESO_OFF_1H 
                            ;                  ;               ; Oscillator Switchover mode disabled
                            ;                  ; Fail-Safe Clock Monitor disabled
                            ; XT oscillator, PLL enabled, XT used by USB
                            
    __CONFIG    _CONFIG2L, _PWRT_ON_2L & _BOR_ON_2L  & _BORV_2_2L  & _VREGEN_ON_2L   
    __CONFIG    _CONFIG2H, _WDT_OFF_2H 
    __CONFIG    _CONFIG3H, _MCLRE_ON_3H & _LPT1OSC_OFF_3H & _PBADEN_OFF_3H & _CCP2MX_ON_3H 
    __CONFIG    _CONFIG4L, _STVREN_ON_4L & _LVP_OFF_4L & _XINST_OFF_4L & _DEBUG_OFF_4L 
    endasm
    DEFINE OSC 48
Unless i need new glasses... can i suspect some wiring or device programmer problem?