Sorry i can't read the file you have attach. I would suggest you to convert it in a BMP, PNG, or whatever else format.

If your schematic software don't allow that, use PrimoPDF. This will act as a virtual printer. So you just need to select PrimoPDF before you print and it will create a PDF file.

Nice nifty and FREE software -> http://www.primopdf.com/

this..
Code:
@  DEVICE  11111101110100b           ; Internal Osc, WDT, PWRT, BOD, MCLR reset, CCP w/ RB2, LVprog disabled,
                                     ; Flash program memory write enabled, No Code Prot., No EEPROM Prot.
                                     ; Fail-safe clock monitor enabled, Internal external switch over enabled.
don't looks familiar. I would suggest you to read the following post

http://www.picbasic.co.uk/forum/showthread.php?t=543

also make sure you have pull-up resistor on PORTB...