LCD's with Shift Registers, and LCDOUT

[HenrikOlsson]

Hi,
I must admit I'm not sure how or if the comparator interfere with the pins when the pins are configured as outputs. However I can't see the comparator pins being set to digital so it might be worth a try to add CMCOM0 = 7.

I also don't see you setting the pins used to outputs but Darrels original code doesn't do it either so it's probably handles by the LCDOUT statement as normal ir the hijack routine. But again, might be worth a try configuring TRISIO properly.

/Henrik.

[picone]

Hi,
I must admit I'm not sure how or if the comparator interfere with the pins when the pins are configured as outputs. However I can't see the comparator pins being set to digital so it might be worth a try to add CMCOM0 = 7.

I also don't see you setting the pins used to outputs but Darrels original code doesn't do it either so it's probably handles by the LCDOUT statement as normal ir the hijack routine. But again, might be worth a try configuring TRISIO properly.

/Henrik.

CMCON0=7 did the trick! Thank you Henrik and Darrell for your help.

On a separate and unrelated note..........how come Darrell's routines (i.e. Instant Interrupts, Slow PWM, LCDanypin, etc) haven't been incorporated into PBP yet? They must add about 50% more functionality to PBP but I'm surprised they aren't part of the software package.

[gr1ph0n]

Is it possible to make naginar's patch to work? I tried the schematic in proteus and I get an error telling me that the "HD44780 controller received command whilst busy".

[gr1ph0n]

I've managed to make it work with minor modifications and connecting E separately. Thank you.