Bruce, you are my hero!

I can't believe it was that simple. I could get it to display Adval, but couldn't think of a good way to convert to decimal. Man, as simple as DEC and DIG !

Now, I'm looking through the manual and can't find anything on DECx except for in the reserved word list. I gather that it displays x digits past the decimal point, but is it in the book somewhere? It's not in the math section...

Anyhow, thank you Bruce! Also, thanks for the info regarding voltage dividers in the other thread. I think I'm pretty well set with the A/D now. My next challenge is to use the LINX Tx and Rx modules I just bought from Rentron to transmit this voltage reading from an R/C plane! Ahh, never a dull moment around here.

Best Regards,

Jeff