Very Simple ICSP Programmer

[togum2000]

Hello Malcolm


I already tested all of the programs of Pic (Winpic, winpic800, wxpic, icprog,.... ) and all with the same problem, My Motherboard is a MSI KM4M-V ( VIA KM400+8237 Chipset ) the Processor is an AMD DURON 1.1Ghz. As to select the correct options of the chip, this everything correct. I hope somebody can help myself with the solution of the problem

[Gusse]

How much voltage you will have on MCLR/VPP pin when you enable Vpp (+13V) from Interface Test (Interface sheet)?
With JDM and standalone PIC I have 10.4V and with ICSP (PIC on applicatio board) 9.3V and it is still working. Sometimes ICSP needs more flashing trials to avoid errors. I think it is because of lower VPP voltage..., but not sure.
When it says "Initialising PIC-Programmer: Success." is should have all setting correct.

BR,
-Gusse-