Hope so, as im quite attached to my hair lol!!
Runs fine when using the VDD as the Vref source, just cant seem to get the fractional digit at all.
Been running it using the VDD for about 5 mins, and it sits at around 22C which at a guess is our room temp lol, and when I hold the sensor inbetween my fingers the temp rises nicely, and when put down again it drops and settles again at 22.

It is just when I try to use the Vref+ (AN3) it goes toes up (not the usual saying, but kiddy friendly)

For a generic temp reader, it would be fine as it is, but for a marine aquarium, I want to be able to get finer readings so that I can use the fans to reduce the temp if the water level rises say 0.5C as stability is the key in marine keeping etc.